Alcatel-Lucent 1643 AMS - ITM-CIT Connector

ITM-CIT interface
...................................................................................................................................................................................................................................
Purpose
This interface must be used for connecting a local ITM-CIT management system.
Connector data
The ITM-CIT connector is an 8-pin RJ45 connector with metal shell for grounding.
Table 4-9 Pin assignment (ITM-CIT cable)
Point on Connector Signal Name Description
1 nc Not connected
2 CTS_CIT Clear To Send
3 GRD Ground
4 TxD Transmitted Data
5 RxD Received Data
6 RTS Request To Send
7 DTR Data Terminal Ready
8 nc Not connected
Cable connection
Please connect the ITM-CIT cable as shown in the figure below.
Figure 4-28 ITM-CIT connector
1
8
System cabling
...................................................................................................................................................................................................................................
365-312-802R7.2
Issue 4, June 2007
Alcatel-Lucent - Proprietary
See notice on first page
4-27