Stripping and connecting a low frequency cable
For stripping and connecting a low frequency cable proceed as follows:
...................................................................................................................................................................................................
1
Follow the steps sequentially as shown in the figure below to perform this procedure.
Legend:
*1 The maximum power of the soldering iron is 50 W. If the
temperature is adjustable, it should be adjusted to a maximum
of 350°.
E ND OF STEPS
...................................................................................................................................................................................................
Figure C-2 Low frequency cable
Cable assembly instructions
SUB-D connector
...................................................................................................................................................................................................................................
C-4
Alcatel-Lucent - Proprietary
See notice on first page
365-312-802R7.2
Issue 4, June 2007
To Next Page
Loading...
