Slot provisioning
...................................................................................................................................................................................................................................
Overview
The slot TS2 must be provisioned for a node in the process of creation.
Before you begin
Before provisioning slots, determine the following:
• Before provisioning the NE slot configuration, it is assumed that the new
configuration of the NE is known. This includes the exact types of units to be
provisioned and the corresponding slot positions for these units.
• For the 1643 AM/AMS, the only slot which may be user assigned is TS2.
• The main unit must be assigned before its corresponding interface units are
assigned.
Procedure
Proceed as follows to provision the slots of an NE (this procedure includes both
assigning and unassigning units):
...................................................................................................................................................................................................
1
Select Provisioning → Equipment → Provisioned NE Components.
Result: The Provisioned NE Components window appears.
...................................................................................................................................................................................................
2
Select the slot TS2 from the list in the window, and click Assign/Unassign.
Result: The Assign NE Units to Slot window appears with information concerning
the selected slot and its associated slots.
...................................................................................................................................................................................................
3
Select the desired operation from the selections at the top of the window.
Result: The correct operation is selected.
...................................................................................................................................................................................................
4
If assigning units, use the pull-down menu for Main Unit and select the correct unit
corresponding to the displayed slot.
Result: The correct unit appears as the new Main Unit.
...................................................................................................................................................................................................
5
Click OK.
Important! When assigning units during node creation, instead of the Provisioned
NE Components window, the window Node Creation - Provision Slots will
reappear.
ITM-CIT installation and NE provisioning
...................................................................................................................................................................................................................................
6-20
Alcatel-Lucent - Proprietary
See notice on first page
365-312-802R7.2
Issue 4, June 2007
To Next Page
Loading...
