Slot state Description
Unassigned Slot is unassigned
Auto Slot is provisioned but waiting for unit. Once the provisioned
unit is present, the slot state will automatically change to
Assigned.
Operation
When assigning units, an operation must be chosen. The choices are described in the
table below.
Operation Description
Assigned Assigns the unit to the slot.
Unassigned The slot is configured to be empty. The NE will not expect any
unit to be present in this slot.
Auto Automatically assigns the unit to the slot once the NE
establishes the presence of a unit of the correct type. Until this
time, the slot acts as Unassigned.
Main unit
The unit provisioned or to be provisioned in the selected slot.
Upper/lower interface
The interfaces directly associated with the displayed Main Unit.
MIB state
The status of the MIB is indicated. The possible values are described in the table
below.
MIB state Description
Empty An empty System Controller (SC) has been inserted or the MIB
was cleared after starting an MIB download automatically by
the management system. If the MIB state is empty, the
management system can proceed with the MIB download.
Filled The NE possesses a valid MIB which has been confirmed.
Filled Unknown The NE has a MIB, however, it is of unknown validity. This
can occur, for instance, if one SC is replaced by another SC
having a MIB.
Filled Not
Confirmed
The NE has a MIB, however, it has not yet been confirmed by
the ITM-CIT. The procedure “Confirm/Update the MIB”
(p. 6-22) gives the steps necessary to confirm the MIB. Once
confirmed, the state will become Filled.
ITM-CIT installation and NE provisioning
Node creation
....................................................................................................................................................................................................................................
365-312-802R7.2
Issue 4, June 2007
Alcatel-Lucent - Proprietary
See notice on first page
6-19
To Next Page
Loading...
