Parameters for NE software installation
...................................................................................................................................................................................................................................
Introduction
The following parameters are used for the NE software installation.
Active store
The software version of the executing code of the software loaded in the NEs active
store is described by four codes.
Code Description
Actual Item Code A code used to uniquely identify any system
component.
Interchangeability Marker An identification mark to indicate interchangeability
among components
Serial Number A number that indicates the sequence number and the
year, date and location of manufacture.
Com Code A code which identifies the component.
Backup store
Shows the software load that is now stored in the backup store. The same codes are
used as in the active store.
Active store state
The following table shows the possible values.
Value Description
Store Active Memory contains a valid code that is being executed.
Store Active Not
Committed
If no association is made between the management system
and the NE after a software switch.
The software that was active before the switch is now in
the backup store. If the association is not made within 2
hours after the switch, the system will switch the stores
back so that the previous active software is made active
again. Therefore, it is not wise to download software
while the active store is in this state.
Installation trouble shooting
...................................................................................................................................................................................................................................
365-312-802R7.2
Issue 4, June 2007
Alcatel-Lucent - Proprietary
See notice on first page
B-7
To Next Page
Loading...
