Alcatel-Lucent 1643 AMS - Create a new ASAP

To Next Page

To Previous Page

Figure

Soldering the ground wire

For soldering the ground wire proceed as follows:

...................................................................................................................................................................................................

Turn the stripped end of the ground wire around the braid before soldering the ground

wire to the braid.

Refer to “Stripping and connecting a low frequency cable” (p. C-4).

Figure C-1 SUB-D assembly steps

Cable assembly instructions

SUB-D connector

...................................................................................................................................................................................................................................

365-312-802R7.2

Issue 4, June 2007

Alcatel-Lucent - Proprietary

See notice on first page

C-3

E ND OF STEPS

...................................................................................................................................................................................................

Main Page

Alcatel-Lucent 1643 AMS - Create a new ASAP

Table of Contents

Other manuals for Alcatel-Lucent 1643 AMS