Safety information
This information product contains hazard statements for your safety. Hazard statements
are given at points where safety consequences to personnel, equipment, and operation
may exist. Failure to follow these statements may result in serious consequences.
Intended audience
This manual is intended for users who wish to install, configure and cable 1643 AM
and 1643 AMS units including all accessories.
This requires that the installation staff has a basic knowledge of SDH and Ethernet
technology. Working on the equipment described in this manual requires also special
training of the personnel.
How to use this information product
This manual is divided into the following sections with a brief description of the
contents of each major part/chapter/appendix:
About this document describes the purpose, intended audience, reason for reissue,
and organisation of this document. This section references related documentation and
explains how to order, make comments or recommend changes to this document.
Part I – Physical and power installation
• Chapter 1, Safety
This chapter provides all relevant information and safety guidelines to safeguard
against personal injury. Furthermore, this chapter may be useful to prevent material
damage to the equipment.
• Chapter 2, General information
This chapter provides all facts which must be known before the system can be
installed, such as environmental requirements, ITM-CIT requirements, EMC/ESD
information, etc.
• Chapter 3, Mechanical installation
This chapter provides all information needed to install 1643 AM and 1643 AMS
units.
• Chapter 4, System cabling
This chapter provides all tasks for a complete system cabling.
• Chapter 5, Powering
This chapter describes the system powering and some final tests which should be
performed to end the physical installation part.
Part II – NE provisioning and stand alone installation test
• Chapter 6, ITM-CIT installation and NE provisioning
This chapter describes the ITM-CIT and NE software installation and the initial NE
provisioning via ITM-CIT.
• Chapter 7, Stand alone test procedures
This chapter provides all tests which must be performed to verify the proper
working of the units/NEs.
About this information product
...................................................................................................................................................................................................................................
xx
Alcatel-Lucent - Proprietary
See notice on first page
365-312-802R7.2
Issue 4, June 2007
,
To Next Page
Loading...
