DS3 interfaces (X2DS3 card)
...................................................................................................................................................................................................................................
Purpose
44736 kbit/s DS3 inputs and outputs can be connected to these interfaces.
Connector data
The DS3 connectors which are located on the X2DS3 option card are DIN 1.6/5.6
coaxial connectors (75 Ω, male).
Cable data
Preferably 75 Ω coax cables should be used (4.1 mm).
Cable connection
Please connect the DS3 cables as shown in the figure below.
NOTE: The routing of the DS3 cables should be in accordance with the recommended
practices of the cables selected. The cables should be strain relieved to prevent any
force from being exerted on the connectors.
Figure 4-41 DS3 cables
to DDF
IN TP2.2 OUT IN OUT
TP2.1
System cabling
...................................................................................................................................................................................................................................
365-312-802R7.2
Issue 4, June 2007
Alcatel-Lucent - Proprietary
See notice on first page
4-41
To Next Page
Loading...
