Alcatel-Lucent 1643 AMS - Aggregate Fiber Cables (AMS Unit)

NOTE: The routing of the fibers should be in accordance with the specifications for the
selected fiber. Care should be taken not to exceed the bending radius of about 30 mm
when placing the fibers. Exceeding the recommended radius may cause distortion and
poor signal quality. All fibers should be strain relieved to prevent any force from being
exerted on the connectors. Clean all connections, as required, before attaching (see
Appendix A, “Fiber cleaning” (p. B-10)).
Figure 4-54 Aggregate fiber cables (AMS unit)
to ODF (aggregates)
Metropolis AMS
®
Lucent Technologies
System cabling Aggregate interfaces (Main board)
....................................................................................................................................................................................................................................
4-56
Alcatel-Lucent - Proprietary
See notice on first page
365-312-802R7.2
Issue 4, June 2007