Figure
Bail latch (type 2)
Proceed as follows to remove this type of SFP:
...................................................................................................................................................................................................
1
Put the fibers away from the transceiver.
...................................................................................................................................................................................................
2
Move the bail upwards (see figure below).
Result: There should be a small click, or it should be visible that the transceiver
was moved a bit out of its latch.
...................................................................................................................................................................................................
3
Grep the SFP transceiver with your own fingers and pull it out.
Important! Don’t pull the bail to get the transceiver out, as the bail might be
teared away from the SFP.
Figure B-3 Unlocking a bail latch (type 1) SFP
Installation trouble shooting
Removing the SFP modules
...................................................................................................................................................................................................................................
365-312-802R7.2
Issue 4, June 2007
Alcatel-Lucent - Proprietary
See notice on first page
B-15
E ND OF STEPS
...................................................................................................................................................................................................
To Next Page
Loading...
