Alcatel-Lucent 1643 AMS - Confirm;Update the MIB

Confirm/Update the MIB
...................................................................................................................................................................................................................................
Overview
A MIB confirmation should be performed during node creation or in any other
situation where the MIB status is “Filled, not confirmed”.
Before you begin
Before confirming or updating the MIB, determine the following:
• Performing a MIB confirmation will cause the NE to reset. A new login, after
waiting several minutes for the reset to take place, will have to be performed.
• Confirming the MIB for an existing NE can result in traffic disruptions.
Procedure
Proceed as follows to confirm the MIB of a NE:
...................................................................................................................................................................................................
1
Select Management → Node Details.
Result: The Node Details window appears. This window allows confirmation or
update of a NE MIB.
CAUTION: Confirming the MIB will result in an NE reset. The current login
session will be terminated. Also, while overwriting the older MIB, traffic can be
affected.
...................................................................................................................................................................................................
2
Click Confirm MIB.
Result: A confirmation window appears.
...................................................................................................................................................................................................
3
Click Yes.
Result: The operation will be started. Confirming the MIB should take several
minutes. During this time, the connection between the ITM-CIT and the NE will be
lost. To re-establish this connection, a login must once again be performed after
waiting for the operation to complete.
...................................................................................................................................................................................................
4
Login again.
...................................................................................................................................................................................................
5
Select Management → Node Details.
Result: The Node Details window appears. In this window, the MIB state can be
viewed. It should now be Filled.
...................................................................................................................................................................................................
6
Click Close.
ITM-CIT installation and NE provisioning
...................................................................................................................................................................................................................................
6-22
Alcatel-Lucent - Proprietary
See notice on first page
365-312-802R7.2
Issue 4, June 2007