Alcatel-Lucent 1643 AMS - Required Tools; Required Test Equipment

Required tools and test equipment
...................................................................................................................................................................................................................................
Tools
A variety of tools is required to carry out the installation procedures. The following
table provides an overview of the required tools.
Table 2-5 Required tools
Quantity Description Comments
1 Metric tool set to be used for physical installation
1 Torque wrench to be used when tightening the AM/AMS units to
the rackframe
1 ESD wrist strap to be worn when handling option boards and SFPs
1 Soldering iron to be used for soldering cables
1 RJ45 crimping tool to be used for terminating RJ45 cables
1 1.6/5.6 coax crimping tool to be used for terminating 1.6/5.6 coax cables
1 PC (Laptop) to be used for NE provisioning via ITM-CIT
Isopropanol, compressed air
and wipes
to be used for fiber cleaning
Test equipment
A variety of test equipment is required to carry out the individual tests. The following
table provides an overview of the required test equipment.
Table 2-6 Required test equipment
Quantity Description Comments
1 SDH Analyser
(STM-1/STM-4)
to be used for performing some installation tests
1 Optical power meter to be used for measuring the optical output power
1 Multimeter to be used for measuring power supplies
1 Adjustable optical attenuator to be used for measuring the receiver sensitivity.
A 15 dB LBO must be used for optical test loops or
for testing the individual ports.
General information
...................................................................................................................................................................................................................................
365-312-802R7.2
Issue 4, June 2007
Alcatel-Lucent - Proprietary
See notice on first page
2-15