Figure
Bail latch (type 1)
Proceed as follows to remove this type of SFP:
...................................................................................................................................................................................................
1
Put the fibers away from the transceiver.
...................................................................................................................................................................................................
2
Move the bail downwards (see figure below).
Result: There should be a small click, or it should be visible that the transceiver
was moved a bit out of its latch.
...................................................................................................................................................................................................
3
Grep the SFP transceiver with your own fingers and pull it out.
Important! Don’t pull the bail to get the transceiver out, as the bail might be
teared away from the SFP.
Figure B-2 Unlocking a MSA latch (type 2) SFP
Installation trouble shooting
Removing the SFP modules
...................................................................................................................................................................................................................................
B-14
Alcatel-Lucent - Proprietary
See notice on first page
365-312-802R7.2
Issue 4, June 2007
E ND OF STEPS
...................................................................................................................................................................................................
To Next Page
Loading...
