Alcatel-Lucent 1643 AMS - Modifying an existing ASAP

Coax connector (1.6/5.6)
...................................................................................................................................................................................................................................
Description
There are the following type of connectors:
• IMS — type 3320.52.1420.0D5 (45°)
• IMS — type 2630.52.1310.0D5 (Straight)
IMS
Important! Use of the correct tools to ensure a proper connection.
For assembling a coax 1.6/5.6 connector proceed as follows:
...................................................................................................................................................................................................
1
Strip the cable according to the dimensions indicated in the next figure and tin the
center conductor.
Important! The stripping lengths depend on the used connector type.
...................................................................................................................................................................................................
2
Pull the crimp outer ferrule over the stripped cable.
...................................................................................................................................................................................................
3
Pull back the cable braid.
...................................................................................................................................................................................................
4
Push the center conductor and the dielectric into the connector housing until the
dielectric stops.
...................................................................................................................................................................................................
5
Solder the inner conductor to the center contact of the connector housing.
...................................................................................................................................................................................................
6
After soldering press the cover into the connector body.
...................................................................................................................................................................................................
7
First roll the cable braid over the termination part (inner ferrule) of the connector and
pull the crimp outer ferrule over that braid.
...................................................................................................................................................................................................
8
Crimp the outer ferrule with a hexagon die 4.6 — AGK 3068 by using the Crimp Tool
— AGK 2365.
Cable assembly instructions
...................................................................................................................................................................................................................................
365-312-802R7.2
Issue 4, June 2007
Alcatel-Lucent - Proprietary
See notice on first page
C-5
E ND OF STEPS
...................................................................................................................................................................................................