Street cabinet mounting (with fan unit)
The 1643 AMS unit can be mounted in an outdoor street cabinet in conjunction with
an AnyMedia Access System. In that case a fan unit containing two fans must be
mounted to the side of the 1643 AMS unit. Proceed as follows to mount the 1643
AMS unit into a street cabinet:
...................................................................................................................................................................................................
1
Unscrew the seven M3x3 screws which are pre-screwed on the right side of the 1643
AMS unit.
...................................................................................................................................................................................................
2
Place the fan unit with its slotted holes over the screw heads.
Important! Pay attention to the correct orientation (see Figure 3-29, “Fixing fan
unit and brackets (AMS unit)” (p. 3-37)). The alarm and LED interface must be
located closer to the 1643 AMS unit than the power interface.
...................................................................................................................................................................................................
3
Shift the fan unit until it cannot be moved any longer.
...................................................................................................................................................................................................
4
Fix the screws through the fan unit holes.
Figure 3-28 Vertical AMS mounting (with bars)
450 mm
Rack
Bar
Bar
AMS
Mechanical installation
AMS unit installation
....................................................................................................................................................................................................................................
3-36
Alcatel-Lucent - Proprietary
See notice on first page
365-312-802R7.2
Issue 4, June 2007
To Next Page
Loading...
