Alcatel-Lucent 5620 - Procedure 8-2 to Configure and Distribute a 9500 Radio Interface Queue Map Policy

8 — 9500 MPR/9500 MPRe QoS policies
8-4 September 2013 Alcatel-Lucent 5620 Service Aware Manager, Release 11.0 R5
3HE 08459 AAAA TQZZA Edition 01
MPR User Guide
Procedure 8-2 To configure and distribute a 9500 Radio Interface
Queue Map policy
When configuring a 9500 Radio Interface Queue Map policy, the following QoS variants
are supported: ODU, MPT-HL, MPT-HC/MPT-MC.
1 Choose Policies→QoS→9500 MPR QoS→ 9500 Radio Interface Queue Map from the
5620 SAM main menu. The 9500 Radio Interface Map Policies form opens.
2 Perform one of the following:
a Configure the Policy scope parameter to Global.
b Configure the Policy scope parameter to Local.
i Configure the Local Node IP Address parameter, if required.
ii Click on the Select button and choose a device.
iii Click on the OK button.
3 Click on the Create button. The 9500 Radio Interface Queue Map Global Policy
(Create) form opens with the General tab displayed.
4 Configure the parameters:
• Auto-Assign ID
• ID
• Description
5 Click on the Radio Interface Queue Map tab.
6 Click on the Create button. The 9500 Radio Interface Queue Map Global Policy
(Create) form opens.
7 Configure the parameters in the Radio Interface and Queue Size Settings panels:
8 Click on the OK button.
9 Click on the Yes button. The 9500 Radio Interface Queue Map Global Policy
(Create) form closes.
• Card ID
• Port ID
• Snmp Port ID
• Status
• Reset all Queues
• Queue 1 Size
• Queue 2 Size
• Queue 3 Size
• Queue 4 Size
• Queue 5 Size
Note — You cannot configure the queue size parameters when the
Reset all Queues parameter is selected.