Alcatel-Lucent 5620 - Procedure 8-3 to Configure and Distribute a 9500 NE Qos Policy

8 — 9500 MPR/9500 MPRe QoS policies
Alcatel-Lucent 5620 Service Aware Manager, Release 11.0 R5 September 2013 8-5
3HE 08459 AAAA TQZZA Edition 01
MPR User Guide
10 Click on the Search button on the 9500 Radio Interface Map Policies form to display
the created policy or policies.
11 To distribute the 9500 Radio Interface Map policy, see the “Policies overview”
chapter in the 5620 SAM User Guide.
Procedure 8-3 To configure and distribute a 9500 NE QoS policy
1 Choose Policies→QoS→9500 MPR QoS→ 9500 NE QoS from the 5620 SAM main
menu. The 9500 NE QoS Policies form opens.
2 Perform one of the following:
a Configure the Policy scope parameter to Global.
b Configure the Policy scope parameter to Local.
i Configure the Local Node IP Address parameter, if required.
ii Click on the Select button and choose a device.
iii Click on the OK button.
3 Click on the Create button. The 9500 NE QOS Global Policy (Create) form opens
with the General tab displayed.
4 Configure the parameters:
• Auto-Assign ID
• ID
• QoS Classification
• Description
The QoS Classification parameter default setting is Disabled. If you configure the
QoS Classification parameter to 802.1p, the Dot1p tab appears. If you configure
the QoS Classification parameter to DiffServ, the DSCP tab appears.
5 Click on the QueueMap policy tab to associate a 9500 Radio Interface Queue Map
Policy.
i Click on the Select button. The Select 9500 Radio Interface Queue Map Policy
form opens.
ii Choose a policy and click on the OK button. The 9500 NE QoS Global Policy
(Create) form reappears.
6 Click on the Apply button. The 9500 NE QoS Global Policy (Create) form closes and
the 9500 NE QOS (Edit) form opens.
7 Click on the Global Queue Setting tab.
8 Choose a Queue number and click on the Properties button. The RadioQ, Global
Policy (Edit) form opens.