3 — 9500 MPR/9500 MPRe device commissioning and management
3-2 September 2013 Alcatel-Lucent 5620 Service Aware Manager, Release 11.0 R5
3HE 08459 AAAA TQZZA Edition 01
MPR User Guide
3.1 9500 MPR/9500 MPRe device commissioning and
management overview
The 9500 MPR requires commissioning and device-specific preconfiguration before
the 5620 SAM can manage it. When this preconfiguration is complete, the
5620 SAM can discover the device. See section 3.2 for the workflow that describes
the sequence of high-level tasks required to commission a 9500 MPR before
discovery by the 5620 SAM.
9500 MPR/9500 MPRe management
The 5620 SAM supports in-band and out-of-band management of devices.
When you configure in-band management only, management traffic between the
5620 SAM and a 9500 MPR/9500 MPRe is transmitted through any port that is
configured for network access, but not the management port. Using in-band
management, the 5620 SAM sends management traffic to the system IP address of
the device, or to an optional L3 management interface.
When you configure out-of-band management only, management traffic between the
5620 SAM and a 9500 MPR/9500 MPRe is transmitted through the management
port of the device. Using out-of-band management, the 5620 SAM sends
management traffic to the management IP address of the device.
See the 5620 SAM User Guide for more information about device bandwidth
management.
9500 MPR/9500 MPRe in-band management
To enable 9500 MPR in-band management, the 5620 SAM requires connectivity to
the 9500 MPR NE, as shown in Figure 3-1 and described in the associated example
configuration steps. Ensure that the trap receiving interface on the 5620 SAM server
is configured with the IP address of the in-band NIC that connects to the 9500 MPR
network.
Figure 3-1 Example of 9500 MPR/9500 MPRe In-band management
20511
Switch or
Router
5620 SAM
server
2.2.2.1
9500 MPR A
Management (TMN) port:
2.2.2.2
Local IP: 10.10.3.5
9500 MPR B
Local IP: 10.10.3.9
9500 MPR network
To Next Page
Loading...
