Alcatel-Lucent 5620 - Procedure 10-3 to Create a 9500 MPR (Dot1 Q) VLAN Service

10 — 9500 MPR VLAN service management
Alcatel-Lucent 5620 Service Aware Manager, Release 11.0 R5 September 2013 10-9
3HE 08459 AAAA TQZZA Edition 01
MPR User Guide
Procedure 10-3 To create a 9500 MPR (dot1q) VLAN service
Perform the following procedures before creating a 9500 MPR (dot1q) VLAN service, as
required:
• Create a customer profile; see the “Customer configuration and service
management” chapter in the 5620 SAM User Guide.
• Create a VLAN group; see Procedure 10-1.
• Create a VLAN path if you need to assign a specific VLAN path to the 9500 MPR
(dot1q) VLAN service; see Procedure 10-2.
• Configure the VLAN endpoints for traffic storm control, VLAN rate limiting, or
dot1q VLAN rate limiting if you need to monitor the input bandwidth; see
Procedure 7-1.
1 Right-click on a 9500 MPR in the navigation tree and choose Properties from the
contextual menu. The 9500 MPR properties form opens with the General tab
displayed.
2 Click on the System Settings tab and set the Bridge Type parameter to 802.1Q.
3 Close the 9500 MPR properties form.
4 Choose Create→Service→VLAN from the 5620 SAM main menu. The VLAN Service
(Create) form opens with the General tab displayed.
5 Click on the Select button to choose a customer to associate with the 9500 (dot1q)
VLAN service. The Select Customer - VLAN Service form opens.
6 Choose a customer for the 9500 MPR (dot1q) VLAN service and click on the OK
button. The Select Customer - VLAN Service form closes and the VLAN (Create)
Service form reappears with the customer information displayed on the General
tab.
7 Configure the parameters:
The Service ID parameter is configurable when the Auto-Assign ID parameter is
disabled.
The SVC Mgr Service ID parameter is configurable when the Auto-Assign ID
parameter is disabled.
The Current OLC State parameter is configurable when you click on the Apply
button on the VLAN Service (Create) form.
8 Click on the VLAN tab and set the Application parameter to 9500 VLAN.
9 Click on the Select button in the Group panel to choose a VLAN group to associate
with the 9500 MPR (dot1q) VLAN service. The Select Group - VLAN Service form
opens.
• Service ID
• Auto-Assign ID
• SVC Mgr Service ID
• Service Name
• Description
• Service Tier
• Service Priority
• Administrative State
• Current OLC State
• Revert OLC State