10 — 9500 MPR VLAN service management
10-10 September 2013 Alcatel-Lucent 5620 Service Aware Manager, Release 11.0 R5
3HE 08459 AAAA TQZZA Edition 01
MPR User Guide
10 Choose a VLAN group and click on the OK button. The Select Group - VLAN Service
form closes and the VLAN (Create) form reappears with the group information
displayed.
11 Perform one of the following:
a Enable the Auto-Assign ID parameter. The 5620 SAM chooses the VLAN ID
when the Auto-Assign ID parameter is enabled.
b Disable the Auto-Assign ID parameter to configure the VLAN ID parameter.
12 Perform one of the following:
a Enable the Specify VLAN Path parameter.
b Disable the Specify VLAN Path parameter to specify a VLAN path by clicking
on the Select button in the VLAN path panel. Go to step 15.
13 Configure the parameters:
• Path Type
• Point to Point VLAN
The Point to Point VLAN parameter is configurable when the Path Type
parameter is set to Hop Based.
14 Click on the Select button in the VLAN Path panel to choose a VLAN Path to
associate with the 9500 MPR (dot1q) VLAN service. The Select VLAN Path - VLAN
Service form opens.
15 Choose a VLAN Path and click on the OK button. The Select VLAN Path - VLAN
Service form closes and the VLAN (Create) form reappears with the group
information displayed.
Note 1 — To create a 9500 MPR VLAN service on an ERPS tail node, set
the Path Type parameter to Ring Based.
Note 2 — The service created using Point to Point VLAN service is
discovered as a standard VLAN service without the point-to-point
option.
Note 3 — You cannot reconfigure the Point to Point VLAN parameter
after you choose a VLAN path. To change the parameter, you need to
delete the selected VLAN path.
Note — The VLAN path may consist of a P2P, P2MP, or Has Tail VLAN
path, and consecutive physical links, non-consecutive physical links, or
radio links spanning NEs.
To Next Page
Loading...
