11 — 9500 MPR VLL service management
11-6 September 2013 Alcatel-Lucent 5620 Service Aware Manager, Release 11.0 R5
3HE 08459 AAAA TQZZA Edition 01
MPR User Guide
28 Perform one of the following:
a Create another site for the VLL service, if required. Repeat steps 9 to 27.
b Complete service creation. Go to step 29.
29 Click on the OK button. The Apipe Service (Create) form closes.
You can use the service topology maps to view the service.
Procedure 11-2 To create a VLL Cpipe service on a 9500 MPR
1 Choose Create→Service→9500 VLL→Cpipe (CEM to CEM/Eth) from the 5620 SAM
main menu. The Cpipe Service (Create) form opens with the General tab
displayed.
2 Click on the Select button to choose a customer to associate with the Cpipe
service. The Select Customer - Cpipe Service form opens.
3 Choose the Default Customer as the customer for the Cpipe service and click on
the OK button. The Select Customer - Cpipe Service form closes and the Cpipe
Service (Create) form reappears with the customer information displayed.
4 Configure the parameters:
The Service ID parameter is configurable when the Auto-Assign ID parameter is
disabled.
The SVC Mgr Service ID parameter is configurable when the Auto-Assign ID
parameter is disabled.
The Current OLC State parameter is configurable when you click on the Apply
button.
Note — If service creation fails or generated NE inconsistencies occur,
see Procedure 4-2.
• Service ID
• Auto-Assign ID
• SVC Mgr Service ID
• Service Name
• Description
• Service Tier
• Service Priority
• Specify VLAN Path
• Path Type
• Current OLC State
• Revert OLC State
Note — To create a 9500 MPR Cpipe service with an ERPS tail node, set
the Path Type parameter to Ring Based.
To Next Page
Loading...
