Alcatel-Lucent 5620 - Page 133

11 — 9500 MPR VLL service management
Alcatel-Lucent 5620 Service Aware Manager, Release 11.0 R5 September 2013 11-5
3HE 08459 AAAA TQZZA Edition 01
MPR User Guide
17 Use the configurable filter and Search button to choose a port, and click on the
OK button. The Select Terminating Port - L2 Access Interface form closes, and the
L2 Access Interface (Create) form displays the port information.
18 Perform one of the following.
a If you selected a value of VCC for the VC Type parameter, go to step 19.
b If you selected a value of VPC for the VC Type parameter, go to step 20.
19 Configure the parameters:
• Outer Encapsulation Value (VPI)
• Inner Encapsulation Value (VCI)
• Outer Encapsulation Value (VPI)
• Inner Encapsulation Value (VCI)
20 Configure the parameters:
• Outer Encapsulation Value (VPI)
• Outer Encapsulation Value (VPI)
21 Click on the ATM tab.
22 Click on the Select button to choose an Ingress ATM Policy. The Select Ingress ATM
Policy - ATM Configuration form opens.
23 Use the configurable filter and Search button to choose a policy, and click on the
OK button. The Select Ingress ATM Policy - ATM Configuration form closes, and the
L2 Access Interface (Create) form displays the policy information.
24 Click on the Select button to choose an Egress ATM Policy. The Select Egress ATM
Policy - ATM Configuration form opens.
25 Use the configurable filter and Search button to choose a policy, and click on the
OK button. The Select Egress ATM Policy - ATM Configuration form closes, and the
L2 Access Interface (Create) form displays the policy information.
26 Click on the OK button. A dialog box appears.
27 Click on the OK button. The L2 Access Interface (Create) form closes, and the
Apipe Site (Create) form reappears with the new interface information displayed
in the service navigation tree.
Note 1 — If ports on a card slot of the 2+2 × Ethernet (EAS) card are
used to create the Apipe service, first configure the Profile Name
parameter on the card slot. See Procedure 7-11 for information about
how to configure this parameter.
Note 2 — If MPT-MC or MPT-HC ports are being used as network ports
on the 2+2 x Ethernet (EAS) card, the peer MAC Address must be
specified for the L2 Access Interface.