Alcatel-Lucent 5620 - Page 132

11 — 9500 MPR VLL service management
11-4 September 2013 Alcatel-Lucent 5620 Service Aware Manager, Release 11.0 R5
3HE 08459 AAAA TQZZA Edition 01
MPR User Guide
6 Choose a VLAN path and click on the OK button. The Select VLAN Path - Apipe
Service form closes and the Apipe Service (Create) form reappears with the VLAN
path information displayed on the General tab.
7 Configure the parameters:
• VLAN ID
• Auto-Assign ID
• Service Class
• PW Label
• Auto-Assign ID
• VC Type
The VLAN ID and PW Label parameters are enabled when the Auto-Assign ID
parameters are disabled.
8 If you configured the Service Class parameter as ATM to Eth in step 7, configure
the MAC Address parameter.
9 In the navigation tree, right-click on a 9500 MPR Apipe Service and choose Create
Apipe Site. The Select Network Element form opens.
For information about adding a GNE site to a VLL service, see Procedure 11-4.
10 Choose an NE from the list and click on the OK button. The Select Network
Element form closes and the Apipe Site (Create) form opens with the General tab
displayed.
11 Configure the parameters:
• Name
• Description
12 Click on the Components tab.
13 Right-click on L2 Access Interfaces and choose Create L2 Access Interface. The L2
Access Interface (Create) form opens with the General tab displayed.
14 Configure the parameters:
• Name
• Description
15 Click on the Port tab.
16 Click on the Select button to choose a terminating port for the L2 access interface.
The Select Terminating Port - L2 Access Interface form opens.
Note — If no VLAN path exists, see Procedure 10-2 for information
about how to create VLAN paths.