3 — 9500 MPR/9500 MPRe device commissioning and management
Alcatel-Lucent 5620 Service Aware Manager, Release 11.0 R5 September 2013 3-5
3HE 08459 AAAA TQZZA Edition 01
MPR User Guide
9500 MPR radio link protection schemes
You can apply 9500 MPR radio link protection by configuring the Protection Type
parameter on the protection tab on supported card slot objects or port objects. See
Procedure 6-4 and 7-12 for more information.
Additionally, you can switch between an in-service protected radio link and a
standby protected link to perform routine maintenance tasks. See Procedure 6-6 for
more information. In-service protected radio links are represented as green links on
the Physical topology map; standby links are shown as blue links.
3.2 Workflow to commission 9500 MPR/9500 MPRe devices
Prepare the 9500 MPR for 5620 SAM management by commissioning the device before
discovery by the 5620 SAM; see the “Device commissioning and management” chapter
in the 5620 SAM User Guide for the generic procedures that apply to this device type.
In addition, perform the following device-specific procedures as required:
1 Enable and configure SNMP on a 9500 MPR device and configure a 5620 SAM
mediation policy and discovery rule; see Procedure 3-1.
2 Configure how and when the 5620 SAM polls the device for MIB changes; see
Procedure 3-2.
3 If required, modify the properties files of 9500 MPR NEs originally discovered using
the 5620 SAM, Release 10.0 R4 or earlier, to enable the opening of NEtO sessions
using the 5620 SAM GUI. See Procedure 3-3.
3.3 9500 MPR/9500 MPRe device commissioning and
management procedures
The following procedures describe how to commission 9500 MPR/9500 MPRe
devices for commissioning and management by the 5620 SAM.
To Next Page
Loading...
