Alcatel-Lucent 5620 - Page 42

3 — 9500 MPR/9500 MPRe device commissioning and management
3-4 September 2013 Alcatel-Lucent 5620 Service Aware Manager, Release 11.0 R5
3HE 08459 AAAA TQZZA Edition 01
MPR User Guide
Figure 3-2 Connectivity example for 9500 MPR/9500 MPRe radio link discovery and management
Table 3-1 Connectivity parameter details
To discover multiple radio links, you must provision the radio ports on the
9500 MPR based on the following criteria.
1 Only one radio port can have PPPRF enabled. The far endpoint on the same link
must have the same configuration as the first endpoint. PPPRF should be
disabled on both endpoints for the second and any subsequent radio links.
2 LinkID requirements include:
• The LinkID must be enabled for all of the port members.
• Expected and Sent values must be equal (for example, 11, 11 or 13, 13).
• For multiple N × (1+x) radio configurations on the same NE, the LINKID must be
unique without overlapping (for example, 1 and 2).
3 As a requirement for the first radio link to be discovered, the remote address must
be present at both endpoints. For subsequent links, alarms cannot be present on
the radio port.
4 When radio link aggregation is enabled for any of the radio links between two
9500 MPRs, all radio links must belong to the same LAG.
22432
Switch
5620 SAM
9500 MPR
1-MSS-4
9500 MPR
2-MSS-4
9500 MPR
3-MSS-8
9500 MPR
4-MSS-4
2x(1+0) RADIO CONFIGURATION
with:
LINKGRP=2
LINKMEMBER=3, 6
3x(1+0) RADIO CONFIGURATION
with:
LINKGRP=1
LINKMEMBER=1, 3, 5
1-MSS-4 2-MSS-4 3-MSS-8 4-MSS-4
2-MSS-4 PPPRF Enabled
LinkID (as assigned)
—PPPRF Enabled
LinkID (as assigned)
—
3-MSS-8 PPPRF Enabled
LinkID (23, 23)
PPPRF Disabled
LinkID (26, 26)
PPPRF Enabled
LinkID (as assigned)
— PPPRF Enabled
LinkID (11, 11)
PPPRF Disabled
LinkID (13, 13)
PPPRF Disabled
LinkID (15, 15)