Alcatel-Lucent 5620 - Procedure 4-4 to Configure a Scope of Command Role for Neto; Access

4 — 9500 MPR/9500 MPRe object configuration
Alcatel-Lucent 5620 Service Aware Manager, Release 11.0 R5 September 2013 4-5
3HE 08459 AAAA TQZZA Edition 01
MPR User Guide
Procedure 4-4 To configure a scope of command role for NEtO access
1 Using an account with an assigned security scope of command role, choose
Administration→Security→5620 SAM User Security from the 5620 SAM main menu.
The 5620 SAM User Security - Security Management (Edit) form opens with the
General tab displayed.
2 Click on the Scope of Command tab.
3 Click on the Create button and choose Profile. The Scope of Command Profile
(Create) form opens with the General tab displayed.
4 Configure the parameters:
• Auto-Assign ID
• Profile ID
• Profile Name
• Description
5 Click on the Roles tab and click on the Add button. The Select Role - Role form
opens.
6 Perform one of the following:
a Choose Admin NEtO launch to open the NEtO with the administration profile.
b Choose Viewer NEtO launch to open the NEtO with the viewer profile.
c Choose Default NEtO launch to open the NEtO with the null profile.
7 Click on the OK button. The Select Role - Role form closes and a dialog box
appears.
8 Click on the OK button.
9 Click on the OK button. The Scope of Command Profile (Create) form closes.
10 Close the 5620 SAM User Security - Security Management (Edit) form.
Note — If the option to run TACACS+ in the network is enabled, choose
the Default NEtO launch.