11 — 9500 MPR VLL service management
Alcatel-Lucent 5620 Service Aware Manager, Release 11.0 R5 September 2013 11-7
3HE 08459 AAAA TQZZA Edition 01
MPR User Guide
5 Click on the Select button to choose a VLAN path to associate with the Cpipe
service. The Select VLAN Path - Cpipe Service form opens.
6 Choose a VLAN path and click on the OK button. The Select VLAN Path - Cpipe
Service form closes and the Cpipe Service (Create) form reappears with the VLAN
path information displayed on the General tab.
7 Configure the parameters:
• Auto-Assign ID
• VLAN ID
The VLAN ID parameter is enabled when the Auto-Assign ID parameter is disabled.
8 Configure the Service Class parameter.
9 If you specified the CEM to Eth option in step 8, configure the parameters:
The VLAN ID parameters are enabled when the associated Auto-Assign ID
parameter is disabled.
10 If you set the Service Class parameter to the SDH to SDH option in step 8, configure
the parameters:
• Clock Source
• Jitter Buffer Depth
11 In the navigation tree, right-click on a 9500 MPR Cpipe Service and choose Create
Cpipe Site. The Select Network Elements - Cpipe Service form opens with a list of
available 9500 MPR sites.
For information about adding a GNE site to a VLL service, see Procedure 11-4.
12 Choose a site and click on the OK button. The Select Network Elements - Cpipe
Service form closes and the Cpipe Site (Create) form opens with the General tab
displayed.
Note 1 — If no VLAN path exists, see Procedure 10-2 for information
about how to create a VLAN path.
Note 2 — You cannot create VLL Cpipe services on a 9500 MPR using the
5620 SAM if the associated VLAN path spans across adjacent physical
links. The VLL Cpipe service must have at least one radio link. If
required, contact your Alcatel-Lucent technical support representative
for alternative VLL Cpipe service configuration options.
• EC ID Tx
• Auto-Assign ID
• EC ID Rx
• Auto-Assign ID
• Clock Source
• Mac Address
To Next Page
Loading...
