Alcatel-Lucent 5620 - Page 114

9 — 9500 MPR service management and service tunnels
9-12 September 2013 Alcatel-Lucent 5620 Service Aware Manager, Release 11.0 R5
3HE 08459 AAAA TQZZA Edition 01
MPR User Guide
20 Configure the parameters:
21 Click on the OK button to save the change and close the Ethernet Ring Element
new Object [Create] form.
Add other ring elements
22 As required, add other ring elements to the radio ring by performing the following:
i Right-click on the Ring Element icon on the Radio Ring [Edit] form and choose
Add Existing Element from the contextual menu. The Select Elements form
opens.
ii Click on the Search button to display a list of radio ring elements.
iii Choose a radio ring element and click on the OK button.
Add the radio ring to a VLAN path
23 Perform Procedure 10-2 to create a VLAN path. Choose Ring Based as the VLAN
path type to add the radio ring to the VLAN.
Create the service on the ERPS topology
24 Perform one of the following to create a service for the 9500 MPR:
a Perform Procedure 10-3 to create a 9500 MPR (dot1q) VLAN service.
b Perform Procedure 11-2 to create a VLL Cpipe service.
• ID
• Auto-Assign ID
• Site ID
• Topology Name
• Description
• CCM Hold Time Down (deciseconds)
• Guard Time
• Ring Protection Link Type
• R-APS Vlan ID
• MEG Level
Note — When you add the radio ring to a VLAN path, you can optionally
extend ERPS (G.8032) support to include tail nodes that connect to the
ERPS ring nodes.
Note 1 — For VLL services, terminating sites must be manually added
to the service. For VLAN services, the sites are auto–populated.
Note 2 — When you create a VLL or VLAN service for the 9500 MPR,
select the Ring Based path type.
Note 3 — The 5620 SAM allows you to discover fiber Ethernet rings
created by the NEtO. However, the 5620 SAM does not support creation
of fiber ring elements and topology.