10 — 9500 MPR VLAN service management
10-6 September 2013 Alcatel-Lucent 5620 Service Aware Manager, Release 11.0 R5
3HE 08459 AAAA TQZZA Edition 01
MPR User Guide
6 Click on the Next button. For ring-based VLAN paths, the Select Ring step appears.
For hop-based VLAN paths, the Specify Vlan Path Constraints step appears.
7 Perform one of the following:
a If you set the Path Type parameter option to Ring Based, go to step 8.
b If you set the Path Type parameter option to Hop Based, go to step 18.
8 Click on the Select button. The Select Ring - VLAN Path form opens.
9 Choose a radio ring from the list and click on the OK button. The Select Ring - VLAN
Path form closes and the ID of the selected Radio Ring appears in the Mgr ID
parameter.
10 Configure the following parameters if a tail node needs to be attached to the ring
element; otherwise, go to step 51.
• Has Tail
• Is Point to Multipoint
Configure the Has Tail parameter if you need standard VLAN paths for the tail
node. Configure the Is Point to Multipoint parameter if you need dot1q VLAN paths
for the tail node.
11 Click on the Next button. The Define the Provisioned Path form opens.
12 Click on the Insert Hop button. The Hop for New Vlan Path [Create] form opens.
13 Click on the Select button to add a network element to the VLAN path. The Select
a Network Element - New VLAN Path form opens.
14 Choose a Network Element and click on the OK button. The Hop for New Vlan Path
[Create] form reappears.
15 Click on the Select button to add a radio link to the VLAN path. The Select Links -
New VLAN Path form appears.
16 Choose a radio link and click on the OK button. The Hop for New Vlan Path [Create]
form reappears.
17 Perform one of the following:
a Repeat steps 12 to 16 to add another tail node to the ring element.
b Click on the Finish button and close button to complete the provisioning of
the VLAN path on a tail node.
18 Perform one of the following:
a If you set the Creation Type parameter option to Manual, go to step 19.
b If you set the Creation Type parameter option to Auto or Point 2 Point, go to
step 30.
19 Configure the Minimum Bandwidth (kbps) parameter.
20 Click on the Next button. The Define Source Site step appears.
To Next Page
Loading...
