3 — 9500 MPR/9500 MPRe device commissioning and management
3-8 September 2013 Alcatel-Lucent 5620 Service Aware Manager, Release 11.0 R5
3HE 08459 AAAA TQZZA Edition 01
MPR User Guide
viii Choose the SNMPv3 user created in step 3 and click on the OK button. The
user is added to the SNMPv3 panel on the Mediation Policy (Create) form.
ix Click on the OK button to save the changes. A dialog box appears.
x Click on the OK button.
xi Click on the OK button. The Mediation (Edit) form closes.
5 Create a discovery rule for the 9500 MPR on the 5620 SAM.
i Perform steps 1 i to 1 x in this procedure to initiate the creation of the
discovery rule.
ii In step 4 of the step form (the Configure Mediation Security step), click on
the Select button and choose the mediation security policy that you created
in step 4 in this procedure for the Read Policy ID, Write Policy ID, and Trap
Policy ID parameters.
iii Perform steps 1 xi to 1 xv in this procedure to complete the creation of the
discovery rule.
6 If you plan to use a 5620 SAM auxiliary server to collect 9500 MPR statistics using
IPv4 or IPv6, perform the following steps.
i Choose Administration→System Information from the 5620 SAM main menu.
The System Information form opens.
ii Click on the Auxiliary Servers tab.
iii Choose the auxiliary server from the list and click on the Properties button.
The Auxiliary Server (View) form opens.
iv Click on the Auxiliary Services tab.
v Select the STATS_SERVICE entry from the list and click on the Properties
button. The Auxiliary Service - STATS_SERVICE (Edit) form opens.
vi If you are using IPv6, configure the IPv6 Address parameter.
vii Click on the OK button. The Auxiliary Service - STATS_SERVICE (Edit) form
closes.
During the subsequent device discovery, the 5620 SAM registers the IPv6
address of the auxiliary server on each discovered 9500 MPR or 9500 MPRe.
viii Click on the OK button. The Auxiliary Server (View) form closes.
ix To configure another auxiliary server, repeat steps 6 iii to viii.
x Close the System Information form.
7 Use the 5620 SAM client to discover the NE and to verify that the NE configuration
allows management of the 9500 MPR. See the “Device discovery” chapter in the
5620 SAM User Guide.
To Next Page
Loading...
