Alcatel-Lucent 5620 - Page 60

5 — 9500 MPR LAG object configuration
5-4 September 2013 Alcatel-Lucent 5620 Service Aware Manager, Release 11.0 R5
3HE 08459 AAAA TQZZA Edition 01
MPR User Guide
3 Right-click on the LAGs icon and choose Create LAG from the contextual menu.
The Create LAG - Define General Properties form opens.
4 Configure the parameters:
• LAG ID
• Auto-Assign ID
5 Click on the Next button. The Create LAG - Configure LAG Parameters form opens.
6 Configure the parameters:
• Name
• Lag Aggregation Type
• Size
7 Click on the Next button. The Create LAG - Configure LACP form opens.
8 Configure the parameters:
• Actor Administration Key
• LACP
• Timeout
9 Click on the Next button. The Create LAG - Configure LAG Members form opens.
10 Click on the Create button to add ports to the LAG. The Create LAG Member - Only
show compatible ports form opens.
11 Click on the Next button. The Create LAG Member - Select Ports form opens.
12 Click on the Search button to display a list of compatible ports. Choose one or
more ports from the list.
13 Click on the Finish button. A dialog box appears.
14 Click on the OK button. The Create LAG - Configure LAG Members form displays
the LAG members.
15 Click on the Finish button. The Create LAG - Wizard Completed form opens.
16 If required, select the View the newly created Port Termination check box to view
the LAG properties.
17 Click on the Close button to close the form. The LAG appears under the LAGs icon
in the navigation tree.
Note — The LACP and Timeout parameters are only applicable to
Ethernet LAGs.
Note — The Show Only Compatible Ports parameter on this form does
not apply to the 9500 MPR. The Class parameter depends on the Lag
Aggregation Type specified in step 6.