6 — 9500 MPR/9500 MPRe shelf object configuration
6-6 September 2013 Alcatel-Lucent 5620 Service Aware Manager, Release 11.0 R5
3HE 08459 AAAA TQZZA Edition 01
MPR User Guide
• ANSI (3.4 or later)
• MPT-HL
• MPT-HC—port protection not supported
• SFP
• ETSI (3.4 or later)
• MPT-HC—port protection not supported
• SFP
2 × STM card
The 2 × STM card supports optical signaling on the 9500 MPR. The 2 × STM card
can be configured in all card slots on the 9500 MPR. Up to two ports can be
configured. A card in a 9500 MPR ETSI or a 9500 MPR ANSI, Release 4.0 or later,
supports the SFP-O and the SFP-E port usage types. See Procedure 7-2 for
information about configuring ports on a 2 × STM card.
16 × E1 (ASAP) card
The 16 × E1 (ASAP) card enables the management of ATM services on the
9500 MPR, through collecting IMA traffic, terminating the IMA groups, and
encapsulating and extracting the ATM cells into and from ATM PW packets toward
the core board. ATM interfaces are established over PDH physical interfaces. ATM
traffic is transported by the ATM PW service and encapsulated in Ethernet frames.
32 × E1 card and 32 × DS1 card
Two 32-port versions (32 × E1 and 32 × DS1) are available:
• provide external interfaces for up to 32 E1 or DS1 ports
• manage the encapsulation and reconstruction of PDH data for standard Ethernet
packets
• send and receive standard Ethernet packets to and from core-enhanced cards
• contain the switch for EPS core protection
• generate internal dc power
See Procedure 7-4 for information about configuring ports on the 32 × E1 card or 32
× DS1 card.
2 × DS3 card
Two DS3 ports are available:
• support up to six units per shelf
• provide 1+1 EPS protection
See Procedure 7-5 for information about configuring ports on the 2 × DS3 card.
To Next Page
Loading...
