7 — 9500 MPR/9500 MPRe port object configuration
7-8 September 2013 Alcatel-Lucent 5620 Service Aware Manager, Release 11.0 R5
3HE 08459 AAAA TQZZA Edition 01
MPR User Guide
6 In the Port Usage panel, configure the ports by choosing one of the following:
• EMPTY
• SFP-O
• SFP-E
a When you set the port to SFP-O, the 1 × STM port is configured and the
Protection tab is enabled. See Procedure 6-4 for more information about card
protection.
b When you set the port to SFP-E, the 1 × STM port is configured but the
Protection tab is disabled.
c When you set the port to EMPTY, all the configured ports revert to an empty
slot after the port is shut down.
7 After the SFP-O port is configured, select Card→Properties. The Card [Edit] form
opens with the Protection tab enabled.
8 From the Protection Type drop-down menu, select 1+1 EPS protection. The SFP-O
port is protected.
9 Expand to the channel level and right-click on a channel. The Channel [Edit] form
opens.
10 Click on the Channel tab. Configure the User Label parameter.
11 Click on the OK button to save the change. A dialog box appears.
12 Click on the Yes button. The Card [Edit] form closes.
Note 1 — You need to shut down the configured port to remove the
port. Select the port and choose Port→Shut Down. Choose
Port→Properties. Configure the Port Usage parameter to EMPTY. The
SFP-O ports are removed. You can now configure other ports.
Note 2 — Protection for cards is at the card level, and cannot be
configured at the port level. Configure protection for the main cards
and the spare cards. Protection is enabled only for the SFP-O port.
Note 3 — 1+1 Protection can be set at different card levels. This
provides redundancy. Both cards should be enabled and configured to
SFP-O before protection is set.
Note 1 — To configure the User Label parameter, you need to set the
port usage type to SFP-O or SFP-E. See step 6.
Note 2 — For channels, the user label can be configured only for the
channels, and not for ports.
To Next Page
Loading...
