System Management
7210 SAS D, E, K OS Basic System Configuration Guide Page 279
System Command Reference
Command Hierarchies
Configuration Commands
NOTE: Not all CLI commands are supported on all the 7210 SAS platforms. Some commands are available
only on some platforms. The support for a particular command for a given platform is either stated explicitly
in the command reference OR in the CLI command description, as applicable. User must use both this
information to know if a particular command is available on a particular platform.
• Configuration Commands on page 279 on page 280
• System Alarm Commands on page 281
• PTP Commands on page 325
• System Time Commands on page 283
• Cron Commands on page 284
• System Administration (Admin) Commands on page 286
• High Availability (Redundancy) Commands on page 330
• System Alarm Contact Commands on page 287
• System Synchronization Commands on page 288
• LLDP System Commands on page 289
• LLDP Ethernet Port Commands on page 289System Resource-Profile Commands for 7210 SAS-D on
page 290
• System Resource-Profile Commands for 7210 SAS-D on page 290
• System Resource-Profile Commands for 7210 SAS-E on page 292
• System Resource-Profile Commands for 7210 SAS-K on page 291
• Fan Controller Commands for 7210 SAS-D and 7210 SAS-D ETR variant with 128MB flash on page
293
• Show Commands on page 294
• Clear Commands on page 295
• Debug Commands on page 295
System Information Commands
config
—system
— boot-bad-exec file-url
—no boot-bad-exec
— boot-good-exec
To Next Page
