Initializing the System and Downloading Software
Page 52 7210 SAS-T Installation Guide
DRAM test second stage
Board Serial Number is 'NS1310C2052'
?Searching for boot.tim on local drives:
Attempting to load file cf1:/boot.tim
Cannot open "cf1:/boot.tim".
Attempting to load from alternate boot device
Looking for boot.tim in cf2:...
File boot.tim not found on cf2:
Looking for boot.tim in uf1:...
boot.tim found in uf1:
Attempting to load file uf1:/boot.tim
Version L-6.0.S73, Sat Aug 3 00:41:40 IST 2013 by builder in /home/builder/6.0S/panos/main
text:(6480576-->23981760) + data:(1143744-->4691824)
Starting at 0xe000000...
PCIe: Port 0 link active, 1 lanes
Total Memory: 1GB Chassis Type: sas Card Type: badami_7210
TiMOS-L-6.0.S73 boot/hops ALCATEL SAS-T 12F10T 4XFP ETR 7210 Copyright (c) 2000-2013 Alca-
tel-Lucent.
All rights reserved. All use subject to applicable license agreements.
Built on Sat Aug 3 00:41:40 IST 2013 by builder in /home/builder/6.0S/pan
TiMOS BOOT LOADER
CPLD Version: 2.8
Extended checks enabled with overhead of 36B
Bss fence checking disabled
Fair scheduler is now enabled
Time from clock is SUN APR 16 09:45:35 2000 UTC
Switching serial output to sync mode... done
Looking for uf1:/bof.cfg ... OK, reading
Contents of Boot Options File on uf1:
primary-image uf1:/both.tim
#eth-mgmt Port Settings:
no eth-mgmt-disabled
eth-mgmt-address 10.135.20.127/24 active
eth-mgmt-route 10.0.0.0/8 next-hop 10.135.20.1
eth-mgmt-autoneg
eth-mgmt-duplex full
eth-mgmt-speed 100
#uplinkA Port Settings:
uplinkA-port 1/1/26
uplinkA-address 0
uplinkA-vlan 0
uplinkA-route 01
#uplinkB Port Settings:
uplinkB-port 1/1/24
uplinkB-address 0
uplinkB-vlan 0
uplinkB-route 0
To Next Page
Loading...
