Configuring the 7210 SAS-T
7210 SAS-T Installation Guide Page 53
#System Settings:
wait 3
persist off
console-speed 115200
no console-disabled
Hit a key within 1 second to change boot parameters...
Configuring Network with eth-mgmt Port Setting.....
No existing config file URL
Primary image location: uf1:/both.tim
Initial DNS resolving preference is ipv4-only
Loading image uf1:/both.tim
Version B-0.0.I1810, Fri Aug 16 21:44:24 IST 2013 by builder in /home/builder/0.0/panos/
main
text:(38748672-->129945408) + data:(4710912-->20751984)
Executing TiMOS image at 0x2800000
Total Memory: 1GB Chassis Type: sas Card Type: badami_7210
TiMOS-B-0.0.I1810 both/hops ALCATEL SAS-T 12F10T 4XFP ETR 7210 Copyright (c) 2000-2013
Alcatel-Lucent.
All rights reserved. All use subject to applicable license agreements.
Built on Fri Aug 16 21:44:24 IST 2013 by builder in /home/builder/0.0/p
___ ___ ___ ___
/\ \ /\__\ /\ \ /\ \
\:\ \ ___ /::| | /::\ \ /::\ \
\:\ \ /\__\ /:|:| | /:/\:\ \ /:/\:\ \
/::\ \ _\/__/ /:/|:|__|__ /:/ \:\ \ _\:\~\:\ \
/:/\:\__\ /\__\ /:/ |::::\__\ /:/__/ \:\__\ /\ \:\ \:\__\
/:/ \/__/ /:/ / \/__/~~/:/ / \:\ \ /:/ / \:\ \:\ \/__/
/:/ / /:/ / /:/ / \:\ /:/ / \:\ \:\__\
\/__/ \/__/ /:/ / \:\/:/ / \:\/:/ /
/:/ / \::/ / \::/ /
\/__/ \/__/ \/__/
Plock checks enabled
Extended checks enabled with overhead of 36B
Sema checks enabled
Lock checks enabled
Bss fence checking disabled
Time from clock is SUN APR 16 10:04:59 2000 UTC
Initial DNS resolving preference is ipv4-only
CRITICAL: CLI #1001 Cannot locate the configuration file -
Using default configuration values.
MAJOR: CLI #1008 The SNMP daemon is disabled. To enable SNMP, execute the command 'con-
fig>system>snmp no shutdown'.
TiMOS-B-0.0.I1810 both/hops ALCATEL SAS-T 12F10T 4XFP ETR 7210 Copyright (c) 2000-2013
Alcatel-Lucent.
All rights reserved. All use subject to applicable license agreements.
Built on Fri Aug 16 21:44:24 IST 2013 by builder in /home/builder/0.0/p
To Next Page
Loading...
