1011| AirGroup AOS-W 6.5.3.x| User Guide
Configuring an AirGroup Integrated Deployment Model
Use the following procedures to enable the AirGroup feature and configure AirGroup services.
Enabling or Disabling AirGroup Global Setting
Starting with AOS-W 6.4, AirGroup is disabled by default. To configure AirGroup global parameters, use the
following procedure:
In the WebUI
To enable or disable the AirGroup global setting using the switch WebUI:
1. Navigate to Configuration > Advanced Services > AirGroup.
2. Select the AirGroup Settings tab.
3. Under Global Setting > AirGroup Status, select enable from the drop-down list to enable the AirGroup
feature.
4. Under Global Settings > AirGroup MDNS Status, select enabled from the drop-down list to enable the
MDNS.
5. Under Global Settings > AirGroup DLNA Status, select enabled from the drop-down list to enable the
DLNA.
6. Under Global Setting > AirGroup CPPM enforce registration, select enable from the drop-down list to
register an AirGroup server on a CPPM server.
For more information on AirGroup CPPM enforce registration, see Configuring CPPM to Enforce
Registration on page 1026.
7. Under Global Setting > AirGroup IPV6 Support, select enable from the drop-down list.
The global AirGroup status must be enabled on the switch to enable AirGroup IPv6 support. For more information,
see AirGroup IPv6 Support on page 1003.
8. Under Global Setting > AirGroup CPPM query interval, enter a value in the range of 1 to 24 hours.
The default value is 10. For more information on AirGroup CPPM query interval, see Configuring the CPPM
Query Interval on page 1021.
9. Under Global Setting > AirGroup location discovery, select enable from the drop-down list.
If enabled, AirGroup user can discover shared devices based on the user’s proximity to the AirGroup server.
If disabled, location based filtering does not apply. Users can discover far servers. For more information on
location attributes in CPPM, see Table 247.
10.Under Global Setting > AirGroup Active Wireless Discovery, select enable from the drop-down list.
If enabled, AirGroup switch actively sends refresh requests to discover wireless servers. If disabled, the
switch sends refresh requests to wired AirGroup servers only.
11.Click Apply.
AirGroup CPPM enforce registration, AirGroup CPPM query interval, AirGroup location discovery, and
AirGroup Active Wireless Discovery parameters are available on the master switch only. The master switch
pushes these configurations to all the applicable local switches.
Table 247 shows the location attributes a device can register with CPPM and the corresponding behavior on
the switch:
To Next Page
Loading...