Alcatel-Lucent AOS-W 6.5.3.x - Page 283

You configure the VLANs, assign IP addresses to each VLAN, and establish the “helper address” to which client
DHCP requests are forwarded.
In the WebUI
1. Navigate to the Configuration > Network > VLAN page. Click Add to add VLAN 60.
a. For VLAN ID, enter 60.
b. Click Apply.
c. Repeat steps A and B to add VLANs 61 and 63.
2. To configure IP parameters for the VLANs, navigate to the Configuration > Network > IP > IP Interfaces
page.
a. Click Edit for VLAN 60.
b. For IP Address, enter 10.1.60.1.
c. For Net Mask, enter 255.255.255.0.
d. Under DHCP Helper Address, click Add. Enter 10.1.1.25 and click Add.
e. Click Apply.
3. In the IP Interfaces page, click Edit for VLAN 61.
a. For IP Address, enter 10.1.61.1.
b. For Net Mask, enter 255.255.255.0.
c. Under DHCP Helper Address, click Add. Enter 10.1.1.25 and click Add.
d. Click Apply.
4. In the IP Interfaces page, click Edit for VLAN 63.
a. For IP Address, enter 10.1.63.1.
b. For Net Mask, enter 255.255.255.0.
c. Under DHCP Helper Address, click Add. Enter 10.1.1.25 and click Add.
d. Click Apply.
5. Select the IP Routes tab.
a. For Default Gateway, enter 10.1.1.254.
b. Click Apply.
In the CLI
(host)(config) #vlan 60
(host)(config) #interface vlan 60
ip address 10.1.60.1 255.255.255.0
ip helper-address 10.1.1.25
(host)(config) #vlan 61
(host)(config) #interface vlan 61
ip address 10.1.61.1 255.255.255.0
ip helper-address 10.1.1.25
(host)(config) #vlan 63
(host)(config) #interface vlan 63
ip address 10.1.63.1 255.255.255.0
ip helper-address 10.1.1.25
(host)(config) #ip default-gateway 10.1.1.254
AOS-W 6.5.3.x | User Guide 802.1X Authentication | 283