Alcatel-Lucent AOS-W 6.5.3.x - Page 284

284| 802.1X Authentication AOS-W 6.5.3.x| User Guide
Configuring WLANs
In this example, default AP parameters for the entire network are as follows: the default ESSID is WLAN-01 and
the encryption mode is TKIP. A second ESSID called guest has the encryption mode set to static WEP with a
configured WEP key.
In this example, the non-guest clients that associate to an AP are mapped into one of two different user VLANs.
The initial AP to which the client associates determines the VLAN: clients that associate to APs in the first floor
of the building are mapped to VLAN 60, and clients that associate to APs in the second floor of the building are
mapped to VLAN 61. Therefore, the APs in the network are segregated into two AP groups, named first-floor
and second-floor. (See Creating an AP group on page 525 for information about creating AP groups.) The guest
clients are mapped into VLAN 63.
Configuring the Guest WLAN
You create and configure the virtual AP profile, guest and apply the profile to each AP group. The guest virtual
AP profile contains the SSID profile, guest which configures static WEP with a WEP key.
In the WebUI
1. Navigate to the Configuration > Wireless > AP Configuration page.
2. In the AP Group list, select first-floor.
3. In the Profiles list, select Wireless LAN and then Virtual AP.
4. To configure the guest virtual AP:
a. Select NEW from the Add a profile drop-down list. Enter guest for the name of the virtual AP profile,
and click Add.
b. In the Profile Details entry for the guest virtual AP profile, select NEW from the SSID profile drop-down
list. A pop-up window allows you to configure the SSID profile.
c. Enter guest for the name of the SSID profile.
d. Enter guest for the Network Name.
e. For Network Authentication, select None.
f. For Encryption, select WEP.
g. Enter the WEP key.
h. Click Apply.
i. Under Profile Details, click Apply.
5. Click on the guest virtual AP name in the Profiles list or in Profile Details to display configuration
parameters.
a. Ensure that you select Virtual AP enable.
b. For VLAN, select 63.
c. Click Apply.
6. Navigate to the Configuration > Wireless > AP Configuration page.
7. In the AP Group list, select second-floor.
8. In the Profiles list, select Wireless LAN and then Virtual AP.
9. Select guest from the Add a profile drop-down list. Click Add.
10.Click Apply.
In the CLI
(host)(config) #wlan ssid-profile guest
essid guest
wepkey1 aaaaaaaaaa