opmode static-wep
(host)(config) #wlan virtual-ap guest
vlan 63
ssid-profile guest
(host)(config) #ap-group first-floor
virtual-ap guest
(host)(config) #ap-group second-floor
virtual-ap guest
Configuring the Non-Guest WLANs
You create and configure the SSID profile “WLAN-01” with the ESSID “WLAN-01” and WPA TKIP encryption. You
need to create and configure two virtual AP profiles: one with VLAN 60 for the first-floor AP group and the
other with VLAN 61 for the second-floor AP group. Each virtual AP profile references the SSID profile “WLAN-
01” and the previously-configured AAA profile “aaa_dot1x”.
In the WebUI
1. Navigate to the Configuration > Wireless > AP Configuration page.
2. In the AP Group list, select first-floor.
3. In the Profiles list, select Wireless LAN, then select Virtual AP.
4. To configure the WLAN-01_first-floor virtual AP:
a. Select NEW from the Add a profile drop-down list. Enter WLAN-01_first-floor, and click Add.
b. In the Profile Details entry for the WLAN-01_first-floor virtual AP profile, select aaa_dot1x from the
AAA Profile drop-down list. A pop-up window displays the configured AAA parameters. Click Apply.
c. From the SSID profile drop-down list, select NEW. A pop-up window allows you to configure the SSID
profile.
d. Enter WLAN-01 for the name of the SSID profile.
e. Enter WLAN-01 for the Network Name.
f. Select WPA for Network Authentication.
g. Click Apply.
h. At the bottom of the Profile Details page, click Apply.
5. Click on the WLAN-01_first-floor virtual AP profile name in the Profiles list or in Profile Details to display
configuration parameters.
a. Ensure that you select Virtual AP enable.
b. For VLAN, select 60.
c. Click Apply.
6. Navigate to the Configuration > Wireless > AP Configuration page.
7. In the AP Group list, select second-floor.
8. In the Profiles list, select Wireless LAN and then Virtual AP.
9. To create the WLAN-01_second-floor virtual AP:
a. Select NEW from the Add a profile drop-down list. Enter WLAN-01_second-floor, and click Add.
b. In the Profile Details entry for the virtual AP profile, select aaa_dot1x from the AAA Profile drop-
down list. A pop-up window displays the configured AAA profile parameters. Click Apply.
c. From the SSID profile drop-down list, select WLAN-01. A pop-up window displays the configured SSID
profile parameters. Click Apply.
d. At the bottom of the Profile Details page, click Apply.
AOS-W 6.5.3.x | User Guide 802.1X Authentication | 285
To Next Page
Loading...