422| Virtual APs AOS-W 6.5.3.x| User Guide
Parameter Description
Advertise
802.11k
Capability
Select this option to allow Virtual APs using this profile to advertise
802.11k capability.
Default: Disabled
Forcefully
disassociate
on-hook voice
clients
Select this option to allow the AP to forcefully disassociate on-hook
voice clients (clients that are not on a call) after period of inactivity.
Without the forced disassociation feature, if an AP has reached its call
admission control limits and an on-hook voice client wants to start a
new call, that client may be denied. If forced disassociation is enabled,
those clients can associate to a neighboring AP that can fulfill their QoS
requirements.
Default: Disabled
Measurement
Mode for
Beacon
Reports
Click the Measurement Mode for Beacon Reports drop-down list and
specify one of the following measurement modes:
n active-all-ch—Enables active beacon measurement mode. In this
mode, the client sends a probe request to the broadcast destination
address on all supported channels, sets a measurement duration
timer, and, at the end of the measurement duration, compiles all
received beacons or probe response with the requested SSID and
BSSID into a measurement report.
n active-ch-rpt—In this mode, the client and returns a report that
contains a list of channels in a regulatory class where a client is
likely to find an AP, including the AP transmitting the AP channel
report.
n beacon-table—Enables beacon-table beacon measurement mode.
In this mode, the client measures beacons and returns a report with
stored beacon information for any supported channel with the
requested SSID and BSSID. The client does not perform any
additional measurements.
n passive—Enables passive beacon measurement mode. In this
mode, the client sets a measurement duration timer, and, at the
end of the measurement duration, compiles all received beacons or
probe response with the requested SSID and BSSID into a
measurement report.
NOTE: If a station doesn't support the selected measurement mode, it
returns a Beacon Measurement Report with the Incapable bit set in the
Measurement Report Mode field.
Default Mode: beacon-table
Channel for
Beacon
Requests in
'A' band
This value is sent in the 'Channel' field of the beacon requests on the 'A'
radio. You can specify values in the range 34 to 165. The default value
is 36.
Channel for
Beacon
Requests in
'BG' band
This value is sent in the 'Channel' field of the Beacon Requests on the
'BG' radio. You can specify values in the range 1 to 14. The default
value is 1.
Channel for
AP Channel
Reports in 'A'
band
This value is sent in the 'Channel' field of the AP channel reports on the
'A' radio. You can specify values in the range 34 to 165. The default
value is 36.
Table 98: 802.11k Profile Parameters
To Next Page
Loading...