Alcatel-Lucent AOS-W 6.5.3.x - Page 423

Parameter Description
Channel for
AP Channel
Reports in
'BG' band
This value is sent in the 'Channel' field of the AP channel reports on the
'BG' radio. You can specify values in the range 1 to 14. The default
value is 1.
Time duration
between
consecutive
Beacon
Requests
This option configures the time duration between two consecutive
beacon requests sent to a dot11k client. By default, the beacon
requests are sent to a dot11k client every 60 seconds. However, if a
different value is required, the bcn-req-time option can be used.
This permits values in the range from 10 seconds to 200 seconds. A
value of 0 is used to indicate that the generation of Beacon Request
frames is turned off.
Time duration
between
consecutive
Link
Measurement
Requests
This option configures the time duration between two consecutive link
measurement requests sent to a dot11k client. By default, link
measurement requests are sent to a dot11k client every 61 seconds.
This parameter permits values in the range from 10 seconds to 200
seconds. A value of 0 is used to indicate that the generation of Link
Measurement Request frames is turned off.
Time duration
between
consecutive
Transmit
Stream
Measurement
Request
This option configures the time duration between two consecutive
transmit stream measurement requests sent to a dot11k client. By
default, the transmit stream measurement requests are sent to a
dot11k client every 90 seconds.
This permits values in the range from 10 seconds to 200 seconds. A
value of 0 is used to indicate that the generation of Transmit Stream
Measurement Request frames is turned off.
Handover
Trigger
Feature
Settings
Profile
This command configures a Handover Trigger Profile. This profile
consists of the configurable parameters for the ‘Wi-Fi Edge Detection
and Handover of Voice Clients’ feature.
Beacon
Report
Request
Settings
Profile
Configure a Beacon Report Request Profile to provide the parameters
for the Beacon Report Request frames.
TSM Report
Request
Settings
Profile
This command configures a TSM Report Request Profile which is used
to provide values to the Transmit Stream/Category Measurement
Request frame.
Table 98: 802.11k Profile Parameters
In the CLI
Use the following command to configure 802.11k profiles. The available parameters for this profile are
described in Table 98.
wlan dotllk <profile-name>
Configuring Radio Resource Management Information Elements
AOS-W supports the following radio resource management information elements (RRM IEs) for APs with
802.11k support enabled. These settings can be enabled through the WebUI or CLI.
AOS-W 6.5.3.x | User Guide Virtual APs | 423