Alcatel-Lucent AOS-W 6.5.3.x - Page 436

436| Virtual APs AOS-W 6.5.3.x| User Guide
Parameter Description
WEP Transmit Key Index Key index that specifies which static WEP key is to be used. Can be 1, 2, 3, or 4.
WPA Hexkey WPA pre-shared key (PSK).
WPA Passphrase WPA passphrase with which to generate a pre-shared key (PSK).
Maximum Transmit
Failures
The AP assumes the client has left and should be deauthorized when the AP
detects this number of consecutive frames were not delivered because the
maximum retry threshold as been exceeded.
BC/MC Rate Optimization Click this checkbox to enable or disable scanning of all active stations currently
associated to an AP to select the lowest transmission rate for broadcast and
multicast frames. This option only applies to broadcast and multicast data
frames; 802.11 management frames are transmitted at the lowest configured
rate.
NOTE: Do not enable this parameter unless instructed to do so by your Alcatel-
Lucent technical support representative.
Rate Optimization for
delivering EAPOL frames
Click this checkbox to use a more conservative rate for more reliable delivery
of EAPOL frames.
Strict Spectralink Voice
Protocol (SVP)
Click this checkbox to enable Strict Spectralink Voice Protocol (SVP)
802.11g Beacon Rate Click this drop-down list to select the beacon rate for 802.11g (use for
Distributed Antenna System (DAS) only). Using this parameter in normal
operation may cause connectivity problems.
802.11a Beacon Rate Click this drop-down list to select the beacon rate for 802.11a (use for
Distributed Antenna System (DAS) only). Using this parameter in normal
operation may cause connectivity problems.
Table 103: SSID Profile Parameters