Parameter Description
Video Multicast Rate
Optimization
When configured, the switch chooses the rate for video multicast frames. You
can configure Modulation Coding Scheme (MCS) rates as well. MCSis an
important setting because it provides for potentially greater throughput.
NOTE: The following information displays the MCS rate if the Short guard
interval in 20 MHz mode setting in High-throughput SSID profile is either
enabled or disabled:
MCS Streams 20 MHz 20 MHz SGI
--- ------- ------ ----------
0 1 6.5 7.2
1 1 13.0 14.4
2 1 19.5 21.7
3 1 26.0 28.9
4 1 39.0 43.3
5 1 52.0 57.8
6 1 58.5 65.0
7 1 65.0 72.2
8 2 13.0 14.4
9 2 26.0 28.9
10 2 39.0 43.3
11 2 52.0 57.8
12 2 78.0 86.7
13 2 104.0 115.6
14 2 117.0 130.0
15 2 130.0 144.4
NOTE: The MCS rates for video multicast are supported in all 802.11n -capable
APs. This is not supported in OAW-AP320 Series AP.
Advertise QBSS Load IE Click this checkbox to enable the AP to advertise the QBSS load element. The
element includes the following parameters that provide information on the
traffic situation:
n Station count: The total number of stations associated to the QBSS.
n Channel utilization: The percentage of time (normalized to 255) the
channel is sensed to be busy. The access point uses either the physical or
the virtual carrier sense mechanism to sense a busy channel.
n Available admission capacity: The remaining amount of medium time
(measured as number of 32us/s) available for a station via explicit
admission control.
The QAP uses these parameters to decide whether to accept an admission
control request. A wireless station uses these parameters to choose the
appropriate access points.
NOTE: Ensure that WMM is enabled for legacy APs to advertise the QBSS load
element. For 802.11n APs, ensure that either wmm or high throughput is
enabled.
Advertise Location
Information
When this option is enabled, APs broadcast their location within a IE carried in
Beacon frames and Probe Response frames. The AP’s latitude, longitude and
altitude can be configured on the Configuration > Wireless> AP Installation
page of the switch WebUI, or using the provision-ap command in the switch
command-line interface.
Table 103: SSID Profile Parameters
AOS-W 6.5.3.x | User Guide Virtual APs | 437
To Next Page
Loading...