536| Access Points AOS-W 6.5.3.x| User Guide
7. If your AP will use Point-to-Point Protocol over Ethernet (PPPoE) to authenticate itself to a service provider,
select the PPPoE Parameters checkbox and enter the following PPPoE values:
n PPPoE User Name: Set the PPPoE User Name for this remote AP.
n PPPoE Password: Enter and then confirm the PPPoE password for this remote AP.
n PPPoE Service Name: Either an ISP name or a class of service configured on the PPPoE server.
8. (Optional) If you want to use this provisioning profile to provision APs with more than one interface, you
must also configure the USB settings and priority levels for this profile. The configuration settings in this
profile are described in Table 120.
9. Click Apply to save your settings.
Parameter Description
Remote-AP Select this checkbox to provision the group of APs as remote APs.
Master IP/FQDN The fully qualified domain name (FQDN) or IP address of the switch to
which the AP is associated.
NOTE: If you configure a master IP/FQDN setting in an AP’s provisioning
profile, this setting will override any LMS and backup LMS settings
configured in an AP’s AP system-profile. Leave the master IP/FQDN
parameter blank if you want the AP to use the LMS or backup LMS values.
PPPOE User Name : Point-to-Point Protocol over Ethernet (PPPoE) password for the AP.
PPPOE Password : Point-to-Point Protocol over Ethernet (PPPoE) password for the AP.
PPPOE Service Name Configures the PPPoE service name for the AP.
USB User Name Configures the USB username for the AP.
USB Password : A USB password, if provided by the cellular service provider.
USB Device Type The USB device type.
USB Device Identifier The USB device identifier.
USB Dial String The dial string for the USB modem. This parameter only needs to be
specified if the default string is not correct.
USB Initialization String The initialization string for the USB modem. This parameter only needs to
be specified if the default string is not correct.
USB TTY device data path The TTY device path for the USB modem. This parameter only needs to be
specified if the default path is not correct.
USB TTY device control path The TTY device control path for the USB modem. This parameter only
needs to be specified if the default path is not correct.
Link Priority Ethernet Set the priority of the wired uplink. Each uplink type has an associated
priority; wired ports having the highest priority by default.
Link Priority Cellular Set the priority of the cellular uplink. By default, the cellular uplink is a
lower priority than the wired uplink; making the wired link the primary link
and the cellular link the secondary or backup link.
Configuring the cellular link with a higher priority than your wired link
priority will set your cellular link as the primary switch link.
Table 120: AP Provisioning Profile parameters
To Next Page
Loading...