Parameter Description
High-throughput Enable
(SSID)
Enable or disable high-throughput (802.11n) features on the SSID.
Default: enabled
Explicit Transmit
Beamforming
Enable/Disable use of Explicit Transmit Beamforming. (For OAW-AP130 Series
only)
If this parameter is disabled, the other transmit beamforming configuration
settings have no effect.
Transmit Beamforming
Compressed Steering
When enabled, the AP can use explicit compressed feedback from clients to
obtain a steering matrix. (For OAW-AP130 Series APs only.)
Default: enabled
Transmit Beamforming
non Compressed Steering
When enabled, the AP can use explicit noncompressed feedback from clients
to obtain a steering matrix. (For OAW-AP130 Series only)
Default: enabled
Transmit Beamforming
delayed feedback support
Enable/Disable delayed feedback/report support in Transmit Beamforming.
(For OAW-AP130 Series only)
Default: enabled
Transmit Beamforming
immediate feedback
support
Enable/Disable immediate feedback/report support in Transmit Beamforming.
(For OAW-AP130 Series only)
Default: enabled
Transmit Beamforming
Sounding Interval
Time interval in seconds between updates of Transmit Beamforming channel
estimation. (For OAW-AP130 Series only)
The supported range is 1-65335 seconds, and the default is 1800 seconds.
Very High throughput
enable (VHT)
Enable or disable very high-throughput (802.11av) features on the SSID.
Default: enabled
Advanced Mesh High-Throughput SSID Profile Settings
Temporal Diversity Enable When a client is not responding to 802.11 packets, the AP will launch two
hardware retries. If you enable this option and hardware retries are not
successful, then the AP will launch and the software retries.
BA AMSDU Enable Enable/Disable Receive AMSDU in BA negotiation.
Legacy stations Allow or disallow associations from legacy (non-HT) stations. By default, this
parameter is enabled (legacy stations are allowed).
Low-density Parity Check If enabled, the AP advertises Low-density Parity Check (LDPC) support LDPC
improves data transmission over radio channels with high levels of
background noise. (For OAW-AP130 Series only)
Maximum number of
spatial streams usable for
STBC reception
Controls the maximum number of spatial streams usable for STBC reception.
0 disables STBC reception, 1 uses STBC for MCS 0-7. Higher MCS values are
not supported. (Supported on the OAW-AP130 Series, OAW-AP170 Series and
OAW-AP105 only. The configured value adjusts based on AP capabilities.)
If transmit beamforming is enabled, STBC is disabled for disabled for
beamformed frames.
AOS-W 6.5.3.x | User Guide Secure Enterprise Mesh | 619
To Next Page
Loading...