Alcatel-Lucent AOS-W 6.5.3.x - Page 622

622| Secure Enterprise Mesh AOS-W 6.5.3.x| User Guide
Parameter Description
Supported MCS set A list of Modulation Coding Scheme (MCS) values or ranges of values to be
supported on this SSID. The MCS you choose determines the channel width
(20MHz vs. 40MHz) and the number of spatial streams used by the mesh
node.
The default value is 1–23; the complete set of supported values. To specify a
smaller range of values, enter a hyphen between the lower and upper values.
To specify a series of different values, separate each value with a comma.
Examples:
2–10
1,3,6,9,12
Range: 0–23.
VHT - Support MCS Map
A list of Modulation Coding Scheme (MCS) values or ranges of values to be
supported on this SSID. The MCS you choose determines the channel width
(20MHz vs. 40MHz vs 80MHz) and the number of spatial streams used by the
mesh node.
The default value is 1–23; the complete set of supported values. To specify a
smaller range of values, enter a hyphen between the lower and upper values.
To specify a series of different values, separate each value with a comma.
Examples:
2–10
1,3,6,9,12
Range: 0–23.
vht-txbf-explicit-enable
Enable/Disable use of VHT Explicit Transmit Beamforming.
Assigning a Profile to an AP Group
1. Navigate to the Configuration > Wireless > AP Configuration window. Select either the AP Group or
AP Specific tab.
n If you selected AP Group, click the AP group name to which you want to assign a new high-throughput
SSID profile.
n If you selected AP Specific, click the AP to which you want to assign a new high-throughput SSID profile
2. Under the Profiles list, expand the Mesh menu, then select Mesh High-throughput SSID profile.
3. In the Profile Details window pane, click the Mesh High-throughput SSID profile drop-down list and
select the desired profile from the list.
4. Click Apply. The profile name appears in the Mesh High-throughput SSID Profile list with your configured
settings. If you configure this for the AP group, this profile also becomes the selected high-throughput SSID
profile used by the mesh portal for your mesh network.
Editing a Profile
1. Navigate to the Configuration > Wireless > AP Configuration window. Select either the AP Group or AP
Specific tab.
n If you selected the AP Group tab, click the AP group name with the profile you want to edit.
n If you selected the AP Specific tab, click the AP with the profile you want to edit.
2. In the Profiles list, expand the Mesh menu, then select Mesh High-throughput SSID profile.
3. In the Profile Details window pane, click the Mesh High-throughput SSID profile drop-down list and
select the name of the profile you want to edit.
4. Change the settings as desired. Table 138 describes the parameters you can configure in this profile.
5. Click Apply.