Figure 84 Configuring RSTP
Since RSTP is enabled by default, the default values appear in the WebUI. Table 145 lists the RSTP defaults and
ranges (when applicable) in the configuration interface mode (config-if).
Feature Default Value/Range
Port Cost The RSTP interface path cost.
Range: 1–65536
Default: Based on Interface type:
Fast Ethernet 10Mbs:100
Fast Ethernet 100Mbs:19
1 Gigabit Ethernet:4
10 Gigabit Ethernet: 2
Priority Change the interface’s RSTP priority
Range: 0–255
Default: 128
Port Fast Change from blocking to forwarding
Default : Disabled
Point-to-Point Set the interface as a point-to-point link
Default : Enabled
Table 145: RSTP Default Values
In the CLI
Change the default configurations using the command line interface:
(host) (config-if)#spanning-tree
cost Change an interface's spanning tree path cost
point-to-point Set interface as point-to-point link
port-priority Change an interface's spanning tree priority
portfast Allow a change from blocking to forwarding
AOS-W 6.5.3.x | User Guide RSTP | 653
To Next Page
Loading...