EasyManuals Logo

Alcatel-Lucent OmniPCX Enterprise User Manual

Alcatel-Lucent OmniPCX Enterprise
108 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #106 background imageLoading...
Page #106 background image
OmniPCX Enterprise
APPENDIX 2
REMARKS & RESTRICTIONS
INSTALLATION PROCEDURE FOR VERSION
J1.410.34.c – RELEASE 10.0
TC1449 34 Ed. 02 / 22 June 2011
ACT 99 can't be synchronizing.
RMA.
No hardware remote reset of the e-CS in case of an Appliance Server.
eRMA.
No hardware remote reset of the e-CS.
The connection is lost in case of Call Server switch-over.
The connection won’t work if the Call Server Application is not running.
Only one simultaneous connection is possible.
eRMA connection works only in case of switching network connection on the GDx (does
not in case of access work through an ABC-F link).
eRMA feature is not available if the concerned Media Gateway encrypts directly the signaling
(MGsec).
Back-up signaling.
The time to recover the telephonic functions in case of back-up link activation is about 3 to 6
minutes depending on the Media Gateway configuration and the type of signaling link used
for the back-up.
The number of digits expected when receiving the back-up call must be managed; see the
Technical Documentation.
The boards used for the establishment of the back-up link must be in the main rack.
In case of Crystal Server (with CPU5 Step3 or CPU6 Step2), it is mandatory to have a Media
Gateway near the main zone to have the backup feature.
In case an APA link is used for back-up signaling, this APA link will be dedicated for the back-
up signaling.
DASS2 or DPNSS links are not supported as back-up links.
No IP Phone in dynamic address.
No 4049 nor 4059 attendant station behind a Media Gateway with potential back-up
link.
Connection of Hybrid link/H323 links behind a Media Gateway with potential back-
up link is possible.
The following features are not accessible/provided when the back-up link is active:
Feed-back tone to the sets when dialing (except for IP-Phone V2).
Access to voice mail 4635H or 4645.
Call Center.
4980 PC MM won’t work because the OTS server will not be accessible.
Only local calls between the sets attached to the Media Gateway (including the IP-Phones
attached to the Media Gateway) or external calls through the local PSTN connections are
possible.
Remote Extension.
Doesn't work with NDDI, APA, DASS2 and DPNSS.

Table of Contents

Other manuals for Alcatel-Lucent OmniPCX Enterprise

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Alcatel-Lucent OmniPCX Enterprise and is the answer not in the manual?

Alcatel-Lucent OmniPCX Enterprise Specifications

General IconGeneral
VoIP ProtocolsSIP, H.323
TypeIP PBX
VoIP CodecsG.711, G.729
IntegrationCRM
SecurityTLS, SRTP
ManagementWeb-based management
RedundancyYes, with redundant CPU and power supply

Related product manuals