OmniPCX Enterprise
INSTALLATION PROCEDURE FOR VERSION
J1.410.34.c – RELEASE 10.0
APPENDIX 2
REMARKS & RESTRICTIONS
Ed. 02 / 22 June 2011 21 TC1449
− Support of 4008/4018 sets in SIP mode.
Refer to technical communication TC1255 4008 / 4018 SIP set deployment with OmniPCX
Enterprise for detailed information regarding the deployment of these sets in an enterprise
network.
− SIP Session Timer.
This feature can be made of two alternative ways: via the Re-Invite method (available in previous
releases) and via the Update method (available from R9.0). Depending of the SIP set possibilities,
this mode may also be set up within the set. If the CS is managed in "Update" mode, it is able to
switch back to "Re-Invite" mode if the set imposes this mode.
For OmniTouch Unified Communication, this new method requires R5.1. The OmniTouch
Unified Communication will use the mode set up on the CS.
− SIP Keep Alive mechanism is available in Release 9.1 only for SIP sets declared in SEPLOS mode
and provided that they support OPTION messages.
− Reason header is also specific to SIP sets declared in SEPLOS mode. This information is intended
for network administrators and Business Partners (information provided in English only in the SIP
trace). In the current version, 4008/4018EE sets in SIP mode display this information, so end-
users will see some English messages despite the set language may be managed in another
language.
10. SETS
10.1. IP Phone V1 – V1S
The IP Phone V1 (4098 RE) sets are no more supported from Release 6.0.
The IP Phone V1 set does not work in Direct RTP.
10.2. IP Phone V2 (e-Reflexe)
− The VoIP Technical Characteristics of the IP-Phones are available on Business Portal.
− Multicast traffic supported before voice degradation, IP Phone reset: 90 Mb/s.
− The initialization duration without binary downloading is about 9 minutes for 2000 IP Phones.
CAUTION
The old 20 and 40 add-on modules are not compliant with the integrated IP Phones V2, the add-
on keys are ignored. These old add-on modules function correctly with TSCIP V1 and V1S sets.
New modules are available and function with TSCIP V1, V1S and IP Phone V2.
These modules are available with the references:
• Add-on 40 keys:
♦ Reflexes module add-on 40 packaged : 3AK 27107 ADAB
♦ Reflexes module add-on 40 : 3AK 26044 ABAA
• Add-on 20 keys:
♦ Reflexes module add-on 20 packaged : 3AK 27107 DDAB
♦ Reflexes module add-on 20 : 3AK 26043 ABAA
To Next Page
Loading...
Need help?
General
